View PCM-3386F-M0A2E_4941592.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

PCM-3386
KB/Mouse LCD IDE CF Socket PCI-104 SODIMM socket USB COM 1/2
Intel(R) Celeron(R) M PCI-104 CPU Module Features
Intel(R) Pentium(R) M Processor 1.1 GHz/1.4 GHz/1.6 GHz or Celeron(R) M 600 MHz Intel(R) 852 GM ICH4 Chipset Supports 36-bit LVDS (48-bit LVDS optional)/ VGA Supports six USB 2.0 ports Supports Embedded Software API and Utility
LPT
Software APIs:
LAN Fan
SMBus H/W Monitor Watchdog GPIO System Throttling Backlight On/Off
Utility:
Audio Connector CRT LVDS Power
BIOS flash Monitoring
Specifications
Processor System CPU Front Side Bus L2 Cache Chipset BIOS Technology Max. Capacity Socket CompactFlash LPT FDD RS-232 RS-232/422/485 K/B Mouse USB Audio Mode Channel PCI-104 Speed Controller Interface Controller VRAM LVDS LCD Dual Independent Display Operating Temperature Operating Humidity Power Type Power Supply Voltage Power Consumption: Typical (WinXP Idle Mode) Power Consumption: Max, Test in HCT Power Management Battery Output Interval Dimensions (L x W) Weight Intel Celeron M 600 MHz Intel Celeron M 1 GHz 400 MHz 400 MHz 512 KB Intel 852GM + ICH4 852GM + ICH4 Award 4-Mbit Award 4-Mbit DDR 200/266 MHz 1 GB 1 x 200-pin SODIMM Card Type I, Type II (option for Micro Drive) 1 (share with FDD) 1 (share with LPT) 2 1 1 6 x USB 2.0 AC97, Line-in, Line-out, Mic-in UDMA 33 1 1 10/100 Mbps Intel 82562EM 1 x RJ-45 by cable Intel 852GM/GMCH Optimized Shared Memory Architecture up to 64 MB system memory 1 x 36-bit LVDS (1 x 48-bit optional) LCD Panel 16:9 wide screen panel supported CRT + LVDS 0 ~ 60 C (32 ~ 140 F) 0% ~ 90% relative humidity, non-condensing ATX +5 V 5%, +12 V 5% +5 V @ 2.06 A (Celeron M 600 MHz) +5 V @ 2.16 A (Celeron M 600 MHz) APM, ACPI Lithium 3 V / 210 mAH System reset Programmable 1 ~ 255 sec 108 x 115 mm (4.3" x 4.5") 0.279 kg (0.62 lb) (with heat-sink)
Memory SSD
I/O Interface
EIDE Expansion Slot Ethernet
Display
Environment
Power
Watchdog Timer Physical Characteristics
Embedded Single Board Computers
All product specifications are subject to change without notice Last updated : 09-Nov-2009
PCM-3386 Board Diagram
Intel Celeron M CPU
CRT Connector LVDS Connector
Intel 852GM Chipset
DDR SODIMM
LAN IDE 6 USB 2.0 Audio Intel ICH4 Chipset
PCI Bus
PCI-104 connector
LPC BUS
BIOS
Super I/O
COM1
COM2
LPT
PS2 KB/MS
Ordering Information
Part No. PCM-3386F-S0A2E CPU L2 Cache 0 KB 512 KB Chipset 852 GM 852 GM CRT Yes Yes LVDS 36-bit 36-bit LAN 1 FE 1 FE USB2.0 RS-232 LPT CF 6 6 2 2 Yes Yes Yes Yes KB/MS Yes Yes PCI-104 Thermal connector Solution Yes Yes Passive Passive Operating Temp. 0 ~ 60 C 0 ~ 60 C ULV Celeron M 1 GHz Celeron M PCM-3386F-M0A2E 600 MHz
Packing List
Part No. 1703060053 1701440350 1701440504 1703200380 1701100202 1700060202 1701200220 1700000897 1700000898 1700000916 1700000918 Description PCM-3386 SBC Y -Cable external cable IDE 44P/44P/40P cable 35cm IDE cable(44pin to 40/44pin) Wire ATX power Ethernet RJ-45 Conn.conversion cable KB / mouse Y-cable COM port cable USB Cable 26cm VGA cable LPT port cable Audio cable (Line-in, Line-out, Mic-in) Quantity 1 1 1 1 1 1 1 1 1 1 1 1
Online Download www.advantech.com/products
Value-Added Software Services
Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms. It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications.
Software APIs
Control
General Purpose Input/Output is a flexible parallel interface that allows a variety of custom connections. It allows users to monitor the level of signal input or set the output status to switch on/off a device. Our API also provides Programmable GPIO, which allows developers to dynamically set the GPIO input or output status. SMBus is the System Management Bus defined by Intel(R) Corporation in 1995. It is used in personal computers and servers for low-speed system management communications. The SMBus API allows a developer to interface a embedded system environment and transfer serial messages using the SMBus protocols, allowing multiple simultaneous device control. I2C is a bi-directional two wire bus that was developed by Philips for use in their televisions in the 1980s. The I2C API allows a developer to interface with an embedded system environment and transfer serial messages using the I2C protocols, allowing multiple simultaneous device control.
Monitor
A watchdog timer (WDT) is a device that performs a specific operation after a certain period of time if something goes wrong and the system does not recover on its own. A watchdog timer can be programmed to perform a warm boot (restarting the system) after a certain number of seconds.
GPIO
Watchdog
SMBus
Hardware Monitor
The Hardware Monitor (HWM) API is a system health supervision API that inspects certain condition indexes, such as fan speed, temperature and voltage.
I2C
Hardware Control
The Hardware Control API allows developers to set the PWM (Pulse Width Modulation) value to adjust fan speed or other devices; it can also be used to adjust the LCD brightness.
Display
Power Saving
The Brightness Control API allows a developer to interface with an embedded device to easily control brightness. Brightness Control CPU Speed
Make use of Intel SpeedStep technology to reduce power power consumption. The system will automatically adjust the CPU Speed depending on system loading.
The Backlight API allows a developer to control the backlight (screen) on/off in an embedded device. Backlight System Throttling
Refers to a series of methods for reducing power consumption in computers by lowering the clock frequency. These APIs allow the user to lower the clock from 87.5% to 12.5%.
Software Utilities
The BIOS Flash utility allows customers to update the flash ROM BIOS version, or use it to back up current BIOS by copying it from the flash chip to a file on customers' disk. The BIOS Flash utility also provides a command line version and API for fast implementation into customized applications. The embedded application is the most important property of a system integrator. It contains valuable intellectual property, design knowledge and innovation, but it is easily copied! The Embedded Security ID utility provides reliable security functions for customers to secure their application data within embedded BIOS. The Monitoring utility allows the customer to monitor system health, including voltage, CPU and system temperature and fan speed. These items are important to a device; if critical errors happen and are not solved immediately, permanent damage may be caused. The eSOS is a small OS stored in BIOS ROM. It will boot up in case of a main OS crash. It will diagnose the hardware status, and then send an e-mail to a designated administrator. The eSOS also provides remote connection: Telnet server and FTP server, allowing the administrator to rescue the system. Flash Lock is a mechanism that binds the board and CF card (SQFlash) together. The user can "Lock" SQFlash via the Flash Lock function and "Unlock" it via BIOS while booting. A locked SQFlash cannot be read by any card reader or boot from other platforms without a BIOS with the "Unlock" feature.
BIOS Flash
eSOS
Embedded Security ID
Flash Lock
Monitoring
Embedded Single Board Computers
All product specifications are subject to change without notice Last updated : 09-Nov-2009

▲Up To Search▲

Price & Availability of PCM-3386F-M0A2E

	To Download PCM-3386F-M0A2E Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .